软管泵滑模机专业的生产厂家

工业软管泵输油不足的可能原因及解决方法齿轮泵故障排除10个隔油环齿轮泵应能连续供油，齿轮啮合重叠系数应大于1。当一对齿轮未脱离啮合时，另一对齿轮已进入啮合状态。这样，当有两对齿轮同时啮合时，两对齿轮的齿啮合线之间形成一个封闭的体积，其中部分油也被困在其中。

Possible causes and solutions for insufficient oil delivery of industrial hose pumps. Gear pump troubleshooting. 10 oil-separating ring gear pumps should be able to supply oil continuously, and the gear meshing overlap factor should be greater than 1. When one pair of gears is not disengaged, the other pair of gears has entered the meshed state. In this way, when there are two pairs of gears meshing at the same time, a closed volume is formed between the tooth meshing lines of the two pairs of gears, and part of the oil is also trapped therein.

 

更换泵管操作步骤：
将连接泵进出口的管道拆开，并将冷却液放出。将进出口管夹内六角螺栓（各四个）拧下。短接管及管卡取出。将进出口前接管螺栓旋出，将前接管、压环及密封圈取出。启动电机，使电机顺时针旋转，将软管拉出。启动电机，使电机逆时针旋转。将新软管一侧涂少量润滑脂（黄油），然后将涂有润滑脂的一侧向泵壳壁，从泵壳上方插入至泵壳中，直至软管到泵壳下方出口的合适位置，停电机。将密封圈套至软管下口泵接管内，将压环装入，拧紧前接管螺栓，装入管夹，拧紧管夹螺栓。启动电机，使电机逆时针旋转，用手或橡胶板堵住软管上方口，软管全自行进入泵中，通过泵侧面窗口观察，使软管贴到泵壳内壁，停电机，按固定的方式将软管安装好。填加冷却液，软管更换即告完成。